Ring Size Calculator
Find your ring size in about a minute.
No printout, no guessing. Calibrate your screen once against any card in your wallet, then measure. For the final piece, our showrooms confirm your size to a quarter measure.
Everything happens on your device. Nothing is uploaded. Works best on a phone held flat.
Match the outline to any card you own.
Lay any card (debit, PAN, Aadhaar, or licence, all the same size) flat across the screen in landscape. The sides will hang over the edge, that is fine. Slide until the top and bottom lines sit exactly on the card's long edges.
It is okay if the card does not fit on screen end to end, or if only part of it is visible. Only the height (the short edge, top to bottom) needs to match. The length can run off the sides.
Tip. Nudge with the plus and minus buttons for a precise match. The closer this is, the more accurate your size.
Place your ring on the circle.
Put a ring that fits the correct finger on the screen. Adjust the circle until it sits just inside the band, filling the inner opening.
Mark the width of your finger.
Lay your finger flat and sideways across the screen, the way it naturally rests, at the base where a ring would sit. Drag the two lines up or down using the handles on the left until each one touches an edge of your finger.
This is a close estimate. For a piece you will wear every day, confirm with the ring method or a showroom fitting.
Start over
